Mechanical tests in the RMS
The RMS has a broad experience in static and quasistatic tests under tensile, compressive, bending or torsional loads as well as combined loads. In the process, we use two Zwick tensile/compression testing machines with a load range of 2 N to 100 kN and a force resolution of 0.01 N as well as a displacement resolution of 0.2 μm. These two machines permit tests either under 3-point or 4-point bending loads or shear. To run the torsional tests, we also use a Zwick machine with a maximum moment of up to 500 Nm, a torque resolution of 0.6 ‰ and an angle resolution <0.003°. Wherever applicable, we carry out the tests with samples or product components made of metals, polymers, ceramic or composite materials on the basis of a standard specification, but we also work according to specific customer needs and demands.
Mechanical characteristics
Independent of the type of load, the materials and components are first subjected to an elastic deformation (linear, reversible) and then possibly to a plastic one (non-linear, irreversible) as well. The static tests permit a characterisation of the sample/product behaviour by defining a series of characteristics such as the modulus of elasticity, the elastic limit, the elongation, the stiffness, the maximum strength, the plastic deformation and finally the breaking strength. All the investigations can be carried out under load- or displacement control. Usually, the load or displacement rate are specified. However, specific profiles are possible as well.
Example of torsional tests
We test the maximum torsion angle and the torsional breaking resistances of titanium screws made of different alloys, and with head-shaft transitions of various designs (picture above). A comparison of Ø 4.5 mm steel (ISO 5832-1) and pure titanium (ISO 5832-2) bone screws shows the clear difference in their behaviour before failure (graph below).
Examples for tensile / compressive loads
In the raw material receiving inspection, we identify and check the modulus of elasticity, the elongation at break, the yield point and the strength under tensile load of standardised round steel and titanium specimens according to DIN EN 10002-1 before processing them to a product.
We test the compressive strength of cylindrical samples made of porous calcium phosphate ceramics in order to check and optimise the relation between the pore size and the strength for their use as bone substitute material (picture below).
Examples for bending tests
We use a 3-point and 4-point bending load to test ceramic specimens made of Al2O3, ZrO2 and their composites in order to evaluate a possible strength-increasing effect of ceramic composite materials.
Our equipment:
Tension/compression/bending
Zwick 1474 and 1475
Range 2 N – 100 kN; resolution 0.01 N and 0.2 μm; force-, displacement-, and elongation-controlled feed.
Testing rate 0.0001 – 800 mm/min; testing room (W x D x H) 400 x 400 x 1000 mm3; flat specimens of 0 – 40 mm width; round specimens of Ø 0 – 30 mm.
Torsion
Zwick TL500
Range 0 – 500 Nm, resolution 0.6‰ and <0.003°, moment- or angle-controlled feed; testing rate of 0.036 – 18,000°/min.
Testing room (W x D x L) 220 x 220 x 680 mm3, clamping jaws with Ø 0 – 200 mm.